Chapel Location
Our chapel is located at 25 South Easton Road, room 205, Glenside, PA, 19038. It is above the Bike Works Motorcycle Shop. The Bike Works Shop is not far from the southeast corner of Easton Road and Glenside Avenue. It is next to the railroad overpass. Our chapel is accessed via the stairway on the right of the Bike Works Shop. At the top of the stairs, walk straight ahead, and you will come to our chapel, room 205.
The chapel is easily accessible using the regional commuter trains R2 Warminster line and R5 Lansdale-Doylestown Line; #22 bus from Broad and Olney Avenue; #77 bus from Chestnut Hill or Jenkintown. Call SEPTA Information at (215)580-7800 or visit SEPTA's web site at http://www.septa.org for time schedules.
If you are driving, you may reach us as follows:
From Schuylkill Expressway:
Go west from center city Philadelphia.
Exit to Roosevelt Expressway (Route 1) going north.
Exit at Broad Street (Route 611 North); turn left onto Broad Street.
Follow Broad Street to a dead end at Cheltenham Avenue.
Turn left onto Cheltenham Avenue.
Follow Cheltenham Avenue to Easton Road, then turn right onto Easton Road.
Drive approximately 2 1/2 miles to Glenside, staying to the right as you pass Arcadia University.
The Bike Works building will be on the right, in the block after the intersection of Easton Road and Glenside Avenue. It is across from the Glenside train station.
From Blue Route(I-476):
Go north on the Blue Route and exit for I-276 (PA Turnpike) east.
Take PA Turnpike to exit 26, Fort Washington.
Enter Route 309 South after passing through tollbooth.
Exit Route 309 at Easton Road/Glenside.
Stay on Easton Road past Arcadia University; stay on right side of the fork.
Continue on Easton Road for approximately 2 miles.
The Bike Works building will be on the right, in the block after the intersection of Easton Road and Glenside Avenue. It is across from the Glenside train station.
From I-95:
Take the Cottman Avenue exit (Route 73).
Travel west on Route 73 until it intersects with Route 152 (Limekiln Pike).
Turn right on to Route 152; continue to Glenside Avenue.
Turn right on Glenside Avenue, and continue to the next traffic light, which is Easton Road.
Turn left. The Bike Works building will be on your right, just before the bridge for the train station.
|
